Lid for Angel Tea Light

prusaprinters

<p>This is a Lid for the "Angel Tea Light" by gzumwalt (<a href="https://www.thingiverse.com/thing:1864269">https://www.thingiverse.com/thing:1864269</a>).</p> <p>I have made two of them, one for 100 % scale, other for 130%.</p> <p>Printed the Angel Tea Light in 130 percent but I missed the lid. It fits an electric candle of 38 mm. The Angel of 130 percent fits perfectly to it. (You see it in the picture, because I didn't close it till the end.)</p> <p>For the Angel of 100 percent is the size of the candle too high or the space from the bace too small, therefore you can see the lid (see image).</p> <p>The hole is for a thread, see image, to open the lid again. The lid fits tight, you can open it without thread, but it's a little bit tricky.</p> <p>Have fun.</p>