Lid Organizer - 1 Size Fits All

thingiverse

*NOTE* I would recommend using PrusaSlicer for this print. I originally sliced with Cura and it had issues creating the overhangs and for some reason added filament strands that blocked the holes on the overhangs. Prusa did not have this issue. Remix of the original Door Organizer by Kaikecc Now that the organizer is separated into two pieces, you can use it for any size lid. I used 1" drywall screws without anchors for my installation and it holds my glass lids just fine. Once the lids are in the organizer, be careful to not put too much downward pressure on the organizer. I had one organizer break so if you are comfortable using the material, you may want to use a higher infill than 20%. I used PrusaSlicer and used snug supports to save on time and material. This worked perfectly. When hanging I measured the diameter of the lid I would like to hang, marked that distance on the wall, and made sure the bottom of the organizers do not go past the diameter.