Lidl XL Gilder conversion to FPV RC glider

thingiverse

See http://www.wing-tips.at/NURFLIDL_-_Umbauanleitung.pdf for the conversion without fpv and motor. (German, but take a look at the picures, here is an english translation https://www.rcgroups.com/forums/showpost.php?p=40417824&postcount=308 ). I've replaced the balsa parts with printed parts and the original fin. I've also changed the servo position to the center of the aileron. A motor holder was added at the back (2 parts, 5 degree down) and a camera holder (2 parts, holder and cover) at the front. If you like to screw the wing, use the wing holder (2 parts, one for the wing, one for the fuselage). In this case it is a good idea to glue a 6mm cfk tube into the lower fuselage. I've printed the wing parts with ABS, 6% infill, 0.4mm wall. The other parts are also abs, but 20% infill and 1.2mm wall. I flies like a dream. but does not like strong wind. Weight is 410g, flying time is about 20 minutes with 3s1300mAh lipo and 1806 motor (2400kv) with 5040 propeller. You will need: - a Lidl XL Glider - Manual by Robert Schweissgut ( see link at the beginning ) - Uhu poor or similar - Tape to fix ailerons - a sharp cutter - 2 servos (5g) - Propeller motor and esc (optional) - 3 channel rc with wing mixer - flight control (optional, I use an omnibusF4 with iNav2.0) - battery( I use a 3s1300mAh, 110g, in the front for a good balance) - fpv equipment (optional) - printed parts ;) - M3 screw and nut ( 1x30mm , 3x10mm, 2x10mm or what is needed for your motor) - Acetone to glue the ABS parts - CFK tube 6x4mm or simmilar to enforce the fuselage, if you build the wing removeable (optional) Have fun !