Light Pipe/Bracket for Onkyo Model A-5, A-7, A-10 Amplifiers

thingiverse

This is a replacement light pipe for Onkyo Model A series vintage audio amplifiers. The original was a rubber piece with a grommet that fit into the front sheet metal. This rubber piece has usually perished and turned to goo. This replacement piece fits over the red plastic in the aluminum front bezel and will need to be held in place with some hot glue some other type of adhesive (probably should not be a permanent adhesive). It has 2 holes so you can secure the power light/LED wire with a mini cable tie. I have a Model A-7 and this should also work on the A-5. I cant speak for the A-10 since I dont have one. That model has 2 lights and I'm not sure how close they are together, so I dont know if 2 of these printed pieces will properly fit beside each other. Layer height, material, and infill amount (no infill actually works fine) can be anything but a black filament is probably best to prevent light from showing through the case when the amp is assembled. Make sure the piece is as flush as possible against the aluminum faceplate before you glue it to prevent this.