Light Switch Guard for flat-styled switches

thingiverse

Do your visitors always turn off the switch that powers the plug to your WiFi? Well worry no more. You can block those jerks with this simple light switch cover. NOTE: See the instructions tab for some important notes on printing and installing this thing. (Inspired by rsee360's thing, for a regular standard light switch.) Instructions Printing Notes: I printed this on a raft exactly the way it is shown in the sample image, however if your printer is goopy and won't span the 8cm gap, then youcan rotate this to it's edge and print it that way. Might even print faster, after I (accidentally) printed it as shown and it worked (to my surprise) I just left it as is. The holes print very nicely when printed. Installation Notes: Make sure you have removed all rafting from the side that touches the light switch panel... if there is any material suck under the screw head holes, your screws may not reach. If you still have problems reaching, you could try taking a 1/4" drill bit (in your hand!) and just rotate it a little in each hole, shaving a little of the material away from the depression. Keep in mind, the material is pretty thin to begin with, and if you scrape away too much, your screw will pop right through the hole. Good luck! Let me know how you made out.