Lightweight single part quadcopter frame (236mm)

thingiverse

This is a lightweight (approx. 70 grams, depending on printer settings/material), single print, 236mm quadcopter frame. Your power distribution board and naze32 flight controller can easily be attached with nylon m3 spacers. The esc's and receiver can be attached to the frame with Ty-raps. On the bottom you can fit your battery with straps or Ty-raps. ### Specifications: * Motor to motor diagonal, 236mm. * Motor holes, 16mm/19mm. * Prop size, max 5inch. * Weight, approx. 70grams, depending on printer settings/material. * Flight controller holes, 30.5mm (fits Naze32). * Different batteries can be fitted to the bottom with straps or ty-raps. ### Products I used: * [MultiStar & Afro Combo Pack](http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp?idproduct=76071&aff=1671893) * [Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 2)](http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp?idproduct=66518&aff=1671893) * [Multistar High Capacity 3S 5200mAh](http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp?idproduct=65267&aff=1671893) This one is a little bit oversized for this quad, but it carries it easily * [AfroFlight Naze32 Acro](http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp?idproduct=69348&aff=1671893) * [Gemfan 5030](http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp?idproduct=77714&aff=1671893) * I used a custom power distribution board. ------------------ #####[Like this design? support me :D](https://www.paypal.me/Slace3D)