Lightweight Y Carriages for Leapfrog Creatr (WIP)

thingiverse

You will need a pair of SHF8 rod support clamps to use these! They are cheap on eBay. The benefits of this setup are: Substantially lighter than stock, a more rigid setup, no squeezing tension on the X rods that caused gantry sag. This setup completely eliminated my X gantry sag, and reduced ringing! X endstop switch mount is not in default position! This is meant for my Titan extruder carriage design. It may still work with stock extruder carriage though. Print with at least 40% infill for strength. Use supports only on the flat parts. Holes shouldn't need supports if your printer is in good tune. These need to be used in a pair, as the geometry is different than the stock carriages. Print Settings Printer: Heavily modified Leapfrog Creatr Rafts: No Supports: Yes Resolution: .2 Infill: 40%