Linear Rail Z Axis Bracket Adapter

prusaprinters

<p>I was working on adding linear rails to my Ender 3, however with the <a href="/make:899298">Z axis linear rail setup</a> I'm using, it originally requires to buy new screws for the Z axis, and at the time I was building it I didn't have any extra screws lying around. So I went and used the organic design of the dual Z axis adapter from Proper printing and basically built it up from scratch (as the model was an STL and it was really hard to modify).</p> <p>The type of linear rails I used are the MGN12H rails; I have only tested this on an Ender 3 since that's the only printer I have.</p> <p>I recommend printing the part out orientated with supports like in the last picture</p> <h3>Print instructions</h3><h3>Category: 3D Printer Parts Summary</h3> <p>I was working on adding linear rails to my Ender 3, however with the <a href="/make:899298">Z axis linear rail setup</a> I'm using, it originally requires to buy new screws for the Z axis, and at the time I was building it I didn't have any extra screws lying around. So I went and used the organic design of the dual Z axis adapter from Proper printing and basically built it up from scratch (as the model was an STL and it was really hard to modify).</p> <p>The type of linear rails I used are the MGN12H rails; I have only tested this on an Ender 3 since that's the only printer I have.</p> <p>I recommend printing the part out orientated with supports like in the last picture</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p>&lt;/div&gt;<strong>Rafts:</strong></div></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p>&lt;/div&gt;</div></p> <p><strong>Notes:</strong></p> <p>I didn't actually print out the part that's on the printer now because I made a mistake in the part during the phase I was test fitting and had already taken the printer apart by the time I found the mistake. I do plan on reprinting the part with MakeShaper Purple ABS</p></p></p>