Lipo Powered USB Charger QC3.0

thingiverse

This is a Lipo powered portable USB charger. There are two versions. Single port and dual port. You will need an XT60 connector (available online or at most RC hobby retailers) and the USB charger module. The link to the specific charger module can be found below. It will take anything from 6v - 32v input source so you can power it from a wide range of Lipo batteries that most of us RC hobbyists have on-hand. Slide the charger module in the charger end and the XT60 connector in the other end and secure them with glue or epoxy (I used super glue aka CA glue). This is designed to be printed in TPU with 100% infill. The parts will fit very tight. Be gentle when pushing the charge module in place. !!!--BE AWARE--!!! This has no low-voltage cutoff so it WILL fully drain and damage your batteries if left connected and forgotten about. Make sure your batteries are charged before using and disconnect when not in use. ***these are NOT affiliate links*** XT60 Connectors: https://www.amazon.com/EKFAY-Connectors-Battery-Quadcopter-Multicopter/dp/B0756RF8DZ/ref=sr_1_3?dchild=1&keywords=black+xt60+connector&qid=1615516096&sr=8-3 Charger Module: https://www.amazon.com/gp/product/B087RHWTJW/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1