Lithophane Light Cube

thingiverse

The 1st thing I've ever designed. All parts can be printed without supports in their current orientation, although a brim or raft is recommended for the corner supports due to their height. The dimensions for the lithophanes are as follows:- Height 122mm (Including 3mm border) Width 122mm (Including 3mm border) Thickness 3mm This will allow the lithophanes to slot nicely into the channels. I recommend that you glue the corner posts into the bottom of the cube, but leave the top as a push fit. This allows you to easily remove the top in order to change the light bulb or switch out between different lithophanes. The additional parts I purchased from Amazon and are as follows:- E27 lamp fitting:- https://amzn.to/2XAC0qP E27 golf ball LED light bulb:- https://amzn.to/2D2OMF5 Standard 2 core power cable with inline switch:- https://amzn.to/2s7lgvH To mount the lamp fitting, feed the power cable through the premade hole in the bottom piece of the cube, unscrew the porcelain fitting from the plastic shroud and wire up the cable to the lamp fitting. Using the same screws, mount the porclain fitting to the mount printed in the centre of the bottom piece of the cube. The screws will cut the thread as you tighten them.