Lizard95 arm extension

thingiverse

Makes your lazy Lizard95 a Lizard108 to fit 2.5 inch props on it. The original motors don't worry about the change in size. I'm using GEMFAN 2540x3 (lemon yellow) on mine and it just goes and goes!!! Super fast but still extremely agile. The prints proof to be strong and solid enough even for more serious crashes. I haven't had to change a single one of them so far. The extension is designed to slide over the original arms and give room for the motor axle on the upper side. I had to use longer screws to mount the motors with a bit of loctite. The smaller holes serve to fix the extension using 1x6mm wood screws (top-down). In a lack of it I used colored electrical tape and went well as of yet :-)