LM8UU Bearing

thingiverse

**UPDATE** THE V2 HAS CHANGES TO THE INNER SPLINES. This could help with installation and printing closer to tolerance. This is a printable version of The LM8UU glide bearing, I attempted to make this for My Anycubic Mega S. These bearings are bear to get printed up, but with lots of tuning and a smidge of luck they will work. Specs are 8mm I.D. 15mm O.D. and 45mm length. There are 3 Different I.D.'s 8.1, 8.15, and 8.18. Pick a good filament that you trust, if you have elephants foot, fail- stringing, fail, room to hot or too cold fail- look at it sideways, fail. you get my drift. I will continue to work on this. I have delusions of printing this in delrin,,,,,HA HA HA Jokes on me. Anyway good luck