lock for nexus pro stock

thingiverse

I noticed the stock's adjustment lever tab was a little shallow and let the stock extend occasionally when picked up or hanging from a strap. This two piece lock clamps together and fits under the lever to stop any motion in the locking tab. It is designed to be a pressure fit so it will be tight. I suggest putting the pieces together one hole at a time in the opposite direction a few times so there is a little leverage to pull them apart while it smooths out the print and allows the pieces to come apart a little easier later. I added a hole for a small screwdriver to pry apart if need be also. Alternatively a small file could be used but its easy to file away too much so be gentle if you go that route.