Loctite Bottle Pegboard Holder Rack

prusaprinters

<p>A simple pegboard holder/rack for up to four Loctite bottles.</p><p>This is a remix from an stl file found on Thingiverse (thing:2690315). The original file had defective hooks and was riddled with mesh errors. I redesigned the hooks and also tried to fix the errors best I could, but the lip of the holder still has some errors; however, if printed at 0.3mm layer height, the errors barely show in the model.&nbsp;</p><p>In uploaded gcode file, I used Prusa Slicer to add a negative mass block across the entire top face of the holder, trimming off around 0.1mm of the top face of the wonky mess, which resulted in a very clear print. As this item is for a workshop environment, that was good enough for me!</p><p>The pegboard hooks are tailored for my Sealey steel 1"/25mm pegboard. They will probably fit other makes, but may need a little fine tuning of the gap between the back of the adaptor and the forward face of the hooks to nip up nice and tight (or loosen off if too tight).</p><p>You may or may not require supports for the upper hooks on the model. On my printers, they don't need supports, but if you don't have bridging dialled in well, you may be some support. You will need supports for the lower pegs if you want the best possible fit on the pegboard.&nbsp;</p>