Loft ladder clip

thingiverse

My father in-law has a loft ladder with a catch that stops the ladder retracting after you've climbed up it, which has been broken for some time. I decided to see if it was possible to make an all-in-one replacement on my REPRAP PRUSA. This is the result. Instructions After printing, you will need to trim the supports at the end of the slider and then trim around the 4 sides of it using a thin blade. I bought a hobby/craft set from my local Homebase (DIY Store) that contains a set of scalpel blades of varying shapes and used a ~5mm wide square-ended blade with the blade on the tip to trim the slider free. I will add a picture of one I made and trimmed when I get home later.