Long-range Antennas Removable Mount for Fatshark

prusaprinters

<p>Print the small part in rigid filament, and the big part in TPU for a nice fit of the sliding assembly mechanism (and for the SMA extension hex part).</p> <p>The small part goes below the faceplate fan of the Fatshark Goggles, you have to remove the shroud with the 4 small screws and then place the "Base" between the fan and shroud.</p> <p>15cm SMA extension is enough to reach the "far" antenna if it has an angled connector on the module side.</p> <p>Prints without supports</p> <p>EDIT: added version that puts the antennas at a 30 degrees angle to each other. Might be useful for traditional diversity receivers where both antennas work independently and you want to maximize coverage. If you request another angle please post a comment.</p>