Long Stem for "Rose with stem"

thingiverse

My wife said long-stem roses were more romantic. Here is an add-on for tc_fea's excellent "Rose with stem" http://www.thingiverse.com/thing:84075 using Nfarrow's rose leaf http://www.thingiverse.com/thing:539491 I created a stem and a choice of a joint with or without leaves. There is also a set of leaves that can be slipped on to the regular short-stem rose. Print Settings Printer: Da Vinci 1.0A (Repetier) Rafts: Doesn't Matter Supports: No Resolution: 0.3 mm Infill: 20% Notes: Recommend printing parts upright with a 2 mm or more brim. These parts have a pretty small contact area with the build plate so they have to be well stuck. Print 2-3 of each part at a time to keep the tips and tops sharp. The leaves are quite delicate while printing. If you have trouble with the leaves tearing, try printing at a lower speed. I used ABS for the models in the photos. Post-Printing 1. Requirements 1 or more "Rose with stem" - http://www.thingiverse.com/thing:84075 2. Assembly Trim any brim and 1st layer bulge from the end of the stem and glue that end into the narrow end of the joint with a little acetone or ABS slurry. Insert your Rose with stem into the top, glue optional. Stand back and admire.