Longer Ray5 10W heavy duty Z axis fine height adjuster remix for 1/4-20 hardware V2

thingiverse

This is a remix of the Ray5 Fine height adjuster by StorminN. I remixed this due to not being able to find much hardware in 6mm, especially full thread hex head bolts in 60mm length. It is remixed to accommodate 1/4-20 hardware. The adjuster knob should be printed with a raft and should be set to have a support blocker in the center section only. The knob is designed to have the print paused at approximately the 70th layer and drop in a 1/4-20 nut (which is why the support blocker for that part only). then when the print is resumed, the nut will be incased in the knob assembly. this will make a very smooth movement between the 1/4-20 x 2 1/2" full thread hex head bolt, and the knob. the top and bottom bracket have also been remixed to accommodate the 1/4-20 hardware and very heavy duty. The lower bracket sits on the back of the laser head by removing 2 rear screws, and putting through the recessed holes in the rear bracket.