Losi Mini T 2.0 Wheel Deep Dish Rev 1

thingiverse

This wheel was refined as to better fit the hex and axle. The hex fit is perfected so the wheel can be removed just like the factory losi wheel (not overly tight). The axle hole diameter was enlarged to glide over the axle without difficulty. The hex depth was revised so the wheel can spin freely when fully tightened. Printed on a MK3s with supports on build plate only (Prusa Slic3r) Print 100 infill and concentric infill throughout Print at .15 resolution with outside face (wheel nut side) ...UP Print using PETG (Used 3D solutions PETG which performed flawlessly) For Prusa MK3s users, try the attached gcode. Gcode is for one and all 4 wheels. 7/19/2020 EDIT #001: After discussing the axle bore fitment with the original author, the axle bore will be tightened to allow for a snug fit. In Fusion360, the bore was set to 49mm (scaled X100). New bore is 43mm (Scaled X100) which is just over 4mm when scaled correctly. Depending on printer tolerances and filament, this may be undersized or...just right. Depending on the printer and the quality used to print this wheel, the bore may need to be drilled for the most precise fit around the axle. The files in this remix have been updated accordingly.