Losi Mini-T 2.0 workstand

thingiverse

This is a custom workstand for the Losi Mini T. The parts and assembly bear some explanation: 1) The base is done in two flat upright pieces to allow printing without any support material. The lower base piece has two clearances for 1/8" thick 2" wide steel plates which can be purchased inexpensively at most hardware retail stores and cut to length with a hacksaw or bandsaw. These act as weights to give the base some heft overall and keep it from skidding around because of the light plastic weight. 2) there are 4 shock stand locations on the base so that you can have the car up on the workstand with the shocks removed and place them in the holes top first to allow filling and oil/air settling by pivoting the car 90 degrees. 3) the upper plate and pivot were done in two pieces to again avoid support material and allow the support upper plate to cup the Mini T's chassis along it's edge bevels to hold the car more securely. I'm currently printing this with 20% infill.