Low Profile Gopro Paintball Mask Mount for Push Unite & others (Maraudr Co MNT-P)

thingiverse

The **MNT-P** is a low profile Action Cam mount designed for the ** PUSH UNITE ** Paintball mask (but may fit various others), ***that doesn't damage the fins of your mask and provides an even lower connection point than any other Mount on the market.*** It utilises 4 M2x20 Screws, which secure the mount in place thanks to a bow that bends around the inner curve of the mask. **RECOMMENDED PRINTER SETTINGS:** Layerheight: 0.1-0.2mm Material: PLA / PETG Nozzle Width: 0.4mm Infill: 100% **IMPORTANT: The lower bridge may break if you print it without 100% infill, change this value to something lower at your own caution.** The MNT-P can be printed without supports and is ready to go once pulled from the buildplate. **INSTALLATION:** _Youll need:_ - 4 M2x20 screws - 4 M2 nuts - 1 M5x20 screw - 1 M5 nut 1. Prepare the mask and take out the Visor for easier installation. 2. Place **2 M2x20 Screws** into the very outer holes of the upper of the mount, and place them through the fins so that the mount sits centered on top of the mask. 3. Turn the mask upside down while holding the Screws and the mount with your fingers, securing that the screws don't fall out of the spaces between the fins. 4. Place the lower bridge and **2 M2 nuts over the 2 most outer M2x20 screws**. 5. Screw in the ** 2 M2 Nuts** slightly into the bridge and the **2 most outer M2x20 Screws**, making sure that the bridge is not yet bending, but if let go of the screws, they wont fall or come out in any way either. 6. Push **the remaining 2 M2x20 Screws** through the most inner holes of the mount, and screw them into place using **the remaining 2 M2 Nuts** on the bridge. 7. Tighten the outer screws, _then_ tighten the most inner ones. You will notice that the inner **M2 Nuts** slide in their holes, which is perfectly normal. 8. make sure that the Mount doesnt move, and is tightly connected with your mask. 9. Finally, Place the **M5 Nut** into it's hole, and screw in the **M5x20 Screw**. Your MNT-P is now ready for use. If you have questions, are interested in our projects or are looking for more goodies, you can find us under **https://maraudr.co** If you enjoy the MNT-P, please leave a comment or a like. If it does not fit your mask, please let us know as well.