Low-profile Wanhao Pulley Stabilizer w/zip-tie

thingiverse

I really liked bpainter's original design for this stabilizer because I did not want to drill into my frame, but my one issue with it was that the bed carriage would bump it when I would get close to y-max. I have remixed it to use a zip-tie to clamp down on the frame and provide a little extra clearance. The bed carriage will ever so slightly scrape the zip-tie, but it is much further into the travel of the bed and has much less impact. Print Settings Printer: Maker Select V2 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 35% Post-Printing Instructions Run a zip-tie through from the bottom of the interior side and loop it over and back around. I had originally planned to make the notch at the top where the head of the zip-tie would rest, but I didn't make it quite big enough for my zip-ties. I used a 30mm M5 bolt to attach it to the pulley frame, which worked out just about perfect.