Lower shock mount Laegendary / Hosim 1:10

thingiverse

Laegendary/Hosim 1:10th scale lower shock pivot mount. This connects to the control arm on the plastic pivot ball. Hold shock shaft tightly (pliers) and unscrew the old mount from the shaft. Be careful not to scratch up the shaft. I'd recommend covering it with rubber or something. After printing... Holding the shaft with pliers as you did to remove the old part carefully start threading the part *straight* into the hole. It will self thread; the last 1mm will be hard to thread but it will go flush with the shaft. I very lightly sanded the cylinder with fine grit to get rid of any mushrooming on the first layer. **Printer accuracy is a must here** Part was designed to be printed with cylinder side towards the build plate. Screenshot included.