LowRider V2 - DW611 Pen Holder

prusaprinters

<p>This is a pen holder that snaps into the dewalt router plate that is standard for the low rider V2. Just pull out the router (or retract it if you have a short pen) and snap in the disc from underneath. Compatible with my Z-Probe so it will know where the pen height is.</p> <p>I highly reccomend printing this in PETG or armadillo/nylon.</p> <p>I like this design since the pen is where the cutting bit normally is, you can preview where cuts will be with your pen and also use it to draw a positioning grid on your table with the cutting extent of your setup.</p> <p>Inspired by alted's pen holder and also those little plastic discs that go inside 45 records (ask your parents).</p> Category: DIY