M10 Hex Nut - 1.5 Pitch - 10mm height - 15 flat to flat diameter

thingiverse

M10 Hex Nut - 1.5 Pitch - 10mm height - 15 flat to flat diameter I am making a spool holder using some left over M10 threaded rod, but I have nut M10 hex Fastener nuts. was inspired by the fact that all the other M10 nuts had a 2mm pitch when clearly it has a 1.5 pitch, Fits and threaded wells, not too tight, and not loose but will try to print at 1.05% larger, but will stick with 1% (original size) when i need to be this tightness it is a short print time, so you can experiment and comment your results. I have had good results with, 30% density Line Infill Rectilinear solid infill pattern (repetier V1.0.4) with my homebuilt I3 rework. 0.4 nozzle 0.40 layer height (quicker but will go with 0.3 or 0.35 next) overnight i can see there has been a few Downloads, if there is any requests for designs, let me know in the comments. comment below if you have had success with this. Instructions M10 Hex Nut - 1.5 Pitch - 10mm height - 15 flat to flat diameter Using the following options: nut_thread_step = 1.5 nut_diameter = 15 nut_height = 10 I have had good results with, 30% density Line Infill Rectilinear solid infill pattern (repetier V1.0.4) with my homebuilt I3 rework. 0.4 nozzle 0.40 layer height (quicker but will go with 0.3 or 0.35 next)