M18 Milwaukee 3 cell battery Wall Control mount

thingiverse

After starting down the rabbit hole of Wall Control, Ive been printing the "DDD Printable Wall Control System" by svideo - Allen Durusha. See his full system at: https://github.com/aderusha/DDD-Printable-Wall-Control-System This remix is for Noggin011's M18 battery rack. This was originally the "Quad" version but I had to cut it down to fit both within the confines of my print capacity of 220mm and between the 1 inch spacing of the Wall Control system. The spacing is slightly smaller between cells as well as having to hack off the 4th cell. This 3 cell format is just large enough to fit the wider High Output XC6.0 & CP3.0 batteries. I dont have any of the 8 or 12's to test fit. This is ideally used with the Sidepiece 2x3 Angle Bracket inverted Flat -Left & Right and the accompanying 6 each 4x10x8 pins. This mounts them for horizontal access. I didnt load the F360 file because it was made from the original STL file and its messy and large with me trying to convert and hack up his original awesome file. I left the original countersunk screw holes to keep it versatile if you ever decide to just screw it to a wall as originally intended.