M2 Standoff hexagon length 20mm

thingiverse

To get the top bracket higher up on the X2 ELF 88mm micro quadcopter frame. After you've printed it use a screw to carefully make the threads. When you get much resistance just unscrew a little bit and then screw it in again. I held the standoff with my t-shirt between my fingers to get a better grip around it. Bottom part of it has a little convergent shape to it, just use a x-acto knife and cut it flush so it gets better contact against your frame. Printed on Anet A8: Print settings: [mm] Layer height: 0.3 Wall line width: 0.4 Skirt brim Line width: 0.4 Wall thickness: 0.8 Top/ Bottom thickness: 1.2 Brim: 3 Infill Density: 60% Print temmp: 210°C Bed Temp: 60°C Customized version of http://www.thingiverse.com/thing:44894 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=44894