M3D D-link Camera Mount

thingiverse

Remixed a D-link camera mount originally done by dtwrv6. This mount is designed for the M3D printer and connects to any d-link camera with a threaded connector and ball joint. Printed a couple different test subjects changing the bracket length, angle, etc. and this final design seems to be the best. The design was originally printed laying flat, but unfortunately support is needed under the threads which screwed them up, so this is why this design is upright. The first clip which was printed laying down seemed to conform to the side of the printer a bit better than the upright model (do to where the supports printed), so you may need to increase the clip size by a factor of 0.1 or 0.2 if you're really picky about that. If not, I just did a small amount of sanding to smooth it out and make it fit a bit nicer. Also, with the threads being so small, the M3D had a hard time printing them smooth, so you may need to clean them up a bit (filing, tap and die set, etc.). I personally used a small pipe wrench just to get that little bit of extra torque which cleaned them out nice. If you're looking to change the length of the bracket or any other modifications, the link below will allow you to do that. If anyone has any issues let me know and I'll see if I can help you out. https://www.tinkercad.com/things/a4rpByPpbMg Print Settings Printer: M3D Rafts: Yes Supports: Yes Resolution: Medium - High Infill: Medium - High Notes: Also Printed using Makebot. Infill 20% Diamond structure (fast)