M3D Quad Fusion Bowden Parts

thingiverse

This is a remix of the original Quaden bowden hat and Quad Fusion plugs by Sindarius. I wanted to create a version with plugs that could free spin on the bearings included in the Quad Fusion. There is no need for the plugs to free spin however I felt it would allow for less resistance while the filament travels against the plugs. The resistance would be minimal but every little bit helps. This bowden hat will hold the plugs in place and requires no screws to hold the plugs in. Remove the bearings from the Quad Fusion and snap them onto the plugs included. Now insert the plugs/bearings back into the Quad Fusion print head and reassemble. Below are the parts I used. I purchased the screw & nut at home depot. Screw used: 1 x M3 - 0.5 X 30mm Nut used: 1 x M3 - 0.5 Nylon Lock Nut 4 x PC4 - M6 Updated Bowden Hat: 12/2/2019