M5 Nut and Bolt

thingiverse

I wanted to push my printer far and i was quite skeptic about this, but for my surprise it did print these parts good after a few tweaks to the 3D model and Cura settings. TURN THESE PARTS IN YOUR SLICER PROGRAM 90 DEGREES!! Some times the screw would get loose from my bed so i played with my settings and with these it worked for both the Screw and Nut. Hope it works with your setup too. I did not use any glue. I was amazed about the quality and that it was even possible to print M5 threads on the CR-10. I have not tried to fit these parts with actual M5 nut and bolts since i had to make minor adjustments on the threads in 3D modelling software to be able to fit these together. Hope you guys will have the same result or better than i did, happy printing!