Mac Keyboard Grippy Feet

prusaprinters

<p>This must be printed with supports. I used the default Cura supports, but I think I would have had an easier time had I gone with Tree supports. When I removed the supports, I did break a couple of the mushroom tabs off by accident, but the grippies have stayed on.</p> <p>I used a clamp to press them into the mold filled with silicon caulk, then left it overnight, and gave them another hour or two to stop feeling tacky.</p> <p>I used 3M stickers to adhere them to the keyboard.</p> <p>The slope is ~4°, the front adds ~.25" (6.35mm) in height, and the rear adds ~.5" (~12.7mm) in height.</p> <p>The pictures were taken after 3-4 months of daily use.</p> Category: Office