Macbook Air Stand - In Desk

thingiverse

This is a 3D printed Macbook air stand. For mounting you Macbook inset in your desk at a 45 degree angle. The stand is about 4 inches deep and the Macbook needs to be mounted with the skinny end going down. This leaves you access to most of the ports. For the 11 inch Macbook Air, Depending on which end you put down, you may cover up the speaker port or make the low side USB port a little tricky to get plugged in. Larger models will have even fewer restrictions. You will need to cut a rectangular hole in your desk to mount this. A cut guide can be seen in the last picture and I including an .stl file for the guide if you want to print it out. I would recommend adhering the finished stand into the table top. I am selling these on e-bay if you would prefer to just buy one:http://www.ebay.com/itm/Macbook-Air-stand-3D-Printed-mounts-in-desk-/141923695754?hash=item210b4fbc8a:g:8T4AAOSwyjBW3lsY Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator 2 Rafts: Doesn't Matter Supports: No Resolution: Fast Infill: 100% Solid Notes: I print this from ABS using solid infill, the walls are pretty thin so there aren't any significant savings by reducing the fill. The max overhand angle is 45 degress, so you should be able to do it without support on most 3d Printers.