Macbook Wall Holder / Mount

prusaprinters

<p>This is a wall mount bracket to hold a macbook pro or other thin laptop. &nbsp;Mounts on screws on a board or wall surface. &nbsp;I put a small piece of double sided tape on the back surface, toward the bottom as well so I slide the bracket onto the screw and then press in place. &nbsp;Use rubber or felt pads inside the contact area of the bracket with the laptop if you wish to avoid possible abrasions on your device over time.</p><p>I wanted to get my laptop off my desk but still have accessible when I need to work elsewhere. &nbsp;This is oriented so the rear exhaust points up… heat rises.<br><br>USB alignment/couplers - <a href="https://www.thingiverse.com/thing:2875142">https://www.thingiverse.com/thing:2875142</a> &nbsp;These are useful so you can keep track of what plug goes in which jack. &nbsp;External monitors seem to enumerate to ports so plugging your monitors into the correct port helps ensure your monitor arrangement in the MacOS remain consistent. &nbsp;I put a black dot on the backside of the brackets as well so I know which way to plug these in. &nbsp;Helpful addition!</p><p>Velcro cable management bracket - <a href="https://www.prusaprinters.org/prints/77309-velcro-strap-anchor">https://www.prusaprinters.org/prints/77309-velcro-strap-anchor</a> &nbsp;(link to velcro straps in there too)</p><p>This is mounted with screws and the brackets slide down onto the screws. &nbsp;I mounted these on a board so I could mount all of my hardware on the board itself and then mount the board to the wall with just two screws so less cleanup/repair when removing the board from the wall.</p>