Machinder - Mazinger Z Jet Scrander

thingiverse

This is a model of the Scrander for the 24" jumbo machinder figure called Mazinger Z. Where you see small holes, these are locations to use 1/4" neodymium magnets. You could glue the pieces into place instead. You may need to cut the fin on your own, if too large for your print bed. The belt is close to the Mazinger Z waist, but isn't a perfect matched fit. I loaded 2 different jet nozzles, one with grooves added, and another without. Not included: I used 3/4" wood dowel if you print the vertical sliced main scrander hull Brass rod was used for the the hinge pins, I believe was 3/32" Pin for the antenna, I believe was 1/8" round Of course, the magnets if wishing to magnet together I had this shared on my own web page, and decided to load it to Thingiverse for others to find.