Mag-nificent Sasquatch Silhouette

thingiverse

This Sasquatch silhouette magnet was inspired from Zennmasters Sasquatch silhouette on Thingiverse. I just modified his silhouette to add a magnet on the back. I had purchased X-LARGE Neodymium Magnets 1/2 x 1/4 inch N48 Strong Rare Earth Disc (on eBay) and wanted to use them on our refrigerator. I figured that the Squatch would make a great refrigerator decoration. Instructions Print it and super glue the magnet in. I used 50% linear fill, 2 perimeters, support material was not turned on. I used PLA filament for mine, just because that is what I had loaded at the time. I have printed 1 and the magnet fit perfect. The magnet sticks out from the end about .055" from the holding cup. Bought magnets from seller: all41n14all at http://www.ebay.com/itm/321244742765?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649