Magazine Coupler - PMAG Gen3

thingiverse

This is a magazine coupler for Gen 3 PMAGs to couple 2 10 round magazines together, intended for those living in stupid states. This does not extend the capacity of the individual magazines. This coupler is under a lot of spring tension so print this with thick walls and lots of infill. So far 1.6mm/80% has held together without it exploding and shooting springs across the room. I am not responsible if this fails at any point in any way. To decouple the magazines insert a small screwdriver or similar device into the slot in the back and rotate it to push up the individual magazine insert buttons, carefully sliding out that magazine. Remember, spring tension.