Mage Knight Token holder

thingiverse

Token organizer. Easy to draw the top tile, even at the bottom. I printed two so that the second tray is the discard tray and to store the overflow of tokens. Can easily fit in the air gap at the top of the Ultimate edition game box (not sure about standard edition). Picture shows all the tokens from the Ultimate edition. If you have the original game, the green 'orc' tokens would have two left over that will not fit when you put the sliding lid on. The lid is 0.25mm narrower than the grooves on the organizer. The fit is going to depend on your printer and common settings that you use. You may still need to tweak the scale of the lid to make sure it slides in with a little friction so that it stays closed. But you can scale down the long direction to 50mm to make a test print. The base of the organizer part is 3mm tall but you may want to increase the infill in these layers to help make it more rigid. Or increase the amount of 'bottom' layers. The posts don't need as much infill. I would use 30% in the bottom 3mm and 10% in the rest. Otherwise no supports are needed and 0.2mm printing should be ok.