Magnetic drawer Child lock

cults3d

https://www.youtube.com/shorts/YY9djICMJGI You can disable this latch by sliding the red lever up into the lock position (don't tighten the screw too tight) Required: - 2 x screws per latch 4x25mm drywall screws work well - 1 magnet per latch - diameter 8mmx5mm long (will accept longer) - superglue 1 magnet per key (REQUIRES 10mm diameter !!!) - the smaller ones don't stick well to the drawer Installation 1. align the latch assembly with the top of the inside of the drawer not touching the front of the drawer (must still move freely) 2. with the latch installed and in the dropped position, close the drawer to a point where you can mark the side of the cupboard where the approximate center of the pin would be 3. Remove the drawer 4. on the inside of the cupboard, install the pin approximately 25 - 28mm from the front edge