Magnetic kitchen rail / aluminium rod holders

prusaprinters

<p>I wanted a place to hang all my kitchen tools that I need in a heated moment in the kitchen. Since I didn't want to drill holes in my rental appartement, I decided to create some simple magnetic end stops for a regular &amp; cheap aluminium rod and hang it to my over-head hood.</p><p>I used a 10mm diameter rod and the hole in the ends has a clearance of .2mm. If you but a 10mm rod it should be fine to print as is, otherwise adjust the hole feature (see screenshot) in Fusion 360 to your liking. I recommend factoring in some clearance though. There is a completely open mid holder as well to even out the load/stress from the two end stops.</p><p>There is a shell inside of the highest part, capable of embedding magnets. Pause the print at layer 110, drop in two 10mm magnets et voila.</p><p>Does not require any supports, has been super steady at holding the load (even with more tools attached to the rail). Printed at 100% infilled PLA at 0.2mm just to be sure but infill could be less.</p>