Magnetic Stand for Raspberry Pi 3 and 4 Cases

prusaprinters

<p>This is a Hex version of the magnetic clip or stand for the cases.</p> <p>Printing this piece is successful when using an ooze shield.</p> <p>There is a small sprocket that holds 4 [1/2" x 1/16"] D81 Magnets (K&amp;J Magnets). The sprocket or magnet frame slides into the gap between the formed hexagonal cells and drops into pockets that align the magnets into the frame and you should touch a few drops of superglue, or abs glue, to hold it in place. I used a flat razer blade and a shim to hold the sprocket in the pocket that registers the magnets.</p> <h3>Print instructions</h3><p>I printed this many times trying to find the best settings to avoid stringing and blobs on every island, finally found an ooze shield that worked well and printed clean parts.</p> <p>The Hex and Snaptop cases fit into this Clip.</p> <p>Printed in ABS</p>