Magnetic Whiteboard Pen Holder - Parametric

thingiverse

Simple magnetic whiteboard pen holder. Magnets must be added before the cavities are covered over. I did this by pausing for 2 minutes before the 13th layer was printed. I added these lines to pause: ;Move print head away G0 X0 ;Pause for 2 minutes G4 S120 ;Move head back to where it started G0 X84 I used a pair of 4mm diameter, 3.5mm height neodymium magnets in each cavity. The cavities must have supports blocked on them using cura as the rest of the pocket needs supports. If you print this be aware that the magnets are slightly too close to each other and they try to jump out of the cavities. It's probably worth moving the cavities apart.