MagSafe 2 cable saver

thingiverse

MagSafe 2 cable strain relief. This should be printed in PETG or ABS. It can be printed on the back with a tiny amount of support. The round holes shouldn't require any but there is a tiny amount of overhang. Id paint the supports out for the holes and just allow a tiny amount for the over hangs. If you're not bothered, it can be printed without any support but there might be a few strings from the unsupported part in which case a small file or drill bit could be used to clear out the holes. The zip tie can be recessed if using a small one. A zip tie may not be needed but its likely a good idea to add one to stop the strain relief from being lost if it gets loose. Ive shown a previous version on the print bed which shows the best orientation for printing. I have uploaded a second version which has had some of the clearance reduced. It fits our connector as a "push fit" and should stay on the connector without a zip tie being needed. The only snag with this version is that it was made to fit ours which is an "aftermarket" connector and might not be exactly the same dimensions as OEM. Please leave any comments if the sizing isn't right for an OEM connector and I will endeavour to produce another with suitable adjustments.