Main shaft seal for traxxas slash 4x4 HCG model 1

thingiverse

So I design this rubber component that I call Main shaft seal for traxxas slash 4x4 HCG model 1 for the purpose of covering up the opening in the chassis where the main shaft comes out. Why because many traxxas slash 4 x 4 owners had issues in regards to the wide opening between the chassis and the main shaft. Because small rocks and debris get in there and could cause problems with the RC vehicle. As a result many owners have attempted to address this issue buy rigging up contraptions to address this issue. Since I have the means so I decided to address this issue by designing this rubber component that I called main shaft seal this component is made out of ninjaflex filament. So I had this component 3D printed out at one of my local hobby shops. So after having this 3D printed component made I tested it out on my slash 4x4 and as a result I had to make some adjustments to get everything flowing right otherwise I was successful with the installation. If you wish to download this file this component must be made of ninjaflex filament or similar filament. Also you will need Super Glue to glue it on to the chassis of the RC vehicle and the photo should give you an idea how to install it. and the photos should give you an idea how it should look after this 3D component is installed. So enjoy this upgrade. But I must warn you be very careful with the super glue and be ready to make adjustments on the Mainshaft seal itself to make sure the drive shaft is doing his job freely as possible.