Mandalorian Helmet Trailer Hitch Cover - 2"

prusaprinters

<p>Remixed the Mandalorian trailer ball cover to fit into a 2" receiver hitch since I don't like leaving my hitch in all the time.</p> <p>Printed with gray PLA, and colored the middle in with a few coats of black sharpie, turned out pretty nice.</p> <p>Printed it with the helmet facing up (flipped 180 degrees from 3D image shown) so could vary the layer height and save time. I used 0.2mm layer height up until the bottom surface of the helmet and then switched to 0.15mm layer height to make it look a bit nicer. I printed without ironing.</p> <p>Unfortunately, it requires a good bit of support material. No support material required inside the receiver hitch portion.</p> <p>Just printed it, will see how it holds up and I'll update if I have any problems with it.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p></div> <p><strong>Supports:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.15</p></div> <p><strong>Infill:</strong></p> <p>30</p> <p><strong>Filament:</strong></p> Prusament PLA <p>Gray</p> </p></p> Category: Automotive