Marblevator remix

thingiverse

I made some small adjustments to the excellent design by gzumwalt and Linax. I kept running into issues where the edges of the track would tear off during printing, so I added a small block of support to the tracks that is 1cm long and as wide as the track itself. This support is only 0.2mm thick, so it should only be printed on one or two layers and can be easily cut off after printing. I also made some modifications to the arm, reducing its width by 0.2mm since the original was a bit too thick for my printer. Since the top already holds it in place somewhat, the arm doesn't need to fit tightly into the tessel. Additionally, I added a few new pieces to the collection: * A 20cm long straight track for longer runs * An 180 degree turn for full turns - I may add another one with room for support in the middle if needed * A combined base and tessel design based on bjorntm's work, extended to include 25mm and 50mm options To-Do list: * Consider splitting or combining some of these designs * Take a closer look at the combined base and tessel design: http://www.thingiverse.com/thing:697680