Market stall

prusaprinters

<p>Market stall and baskets sized for Sylvanian families or Playmobil. There are links to most of the wares int the picture and to also to a <a href="https://www.prusaprinters.org/prints/19487-cash-register-separate-drawer">Cash register, coins, extra baskets and stands</a> below.</p><p>Special thanks to Thingiverse user ritabunny who sent pictures and ideas to use as inspiration!</p><p><strong>Description</strong><br>The booth has 4 main parts which stays together without glue. The awning can either be printed in parts to get a multi-colored awning, or as just one or two pieces. The awning doesn't need to be glued but it's probably best to glue the different awning parts together if they are printed separately. No glue has been used for the market booth in the printed pictures.</p><p><strong>Wares &amp; stuff</strong><br><a href="https://www.prusaprinters.org/prints/19487-cash-register-separate-drawer">Cash register, coins, extra baskets and stands</a></p><p>Lettuce, carrots, potatoes and onion are from my <a href="https://www.thingiverse.com/thing:3048134">"Vegetable garden"</a></p><p>Buns are from my <a href="https://www.prusaprinters.org/prints/19467-cakes-and-biscuits">"Cakes and biscuits"</a> set</p><p>Also see this nice looking <a href=" https://www.thingiverse.com/thing:3437927 ">Jar</a> and this <a href="https://www.thingiverse.com/make:614122 ">make</a> by RitaBunny for more ideas on how to improve the market stall.</p><p><a href="https://www.thingiverse.com/thing:31900">Pumpkin</a> by KellyBC</p><p><a href="https://www.thingiverse.com/thing:438279">The Yellow Pepper</a> by AmazingDesign</p><p><a href="https://www.thingiverse.com/thing:457861">The Corn</a> by AmazingDesign<br><a href="https://www.thingiverse.com/thing:474522">Corn on the Cob</a> by JamesWhite (I mirrored the parts, combined them and printed in one piece)</p><p><a href=" https://www.thingiverse.com/thing:155180">Pear </a>by Nat.Net (I reinforced the stalk a bit)</p><p>The banana I got from 3D paint but I'm sure there are many to find on Thingiverse too.</p><h3>Print instructions</h3><p>I used supports for the main stand part but I am not sure that is actually needed. Print the awning standing on the side to avoid having to use support (gluing the print bed is recommended).&nbsp;</p><p>&nbsp;I have tried both printing the awning as separate parts and as one part. Painting nice looking stripes is a little bit tricky when printing as one part so I think I preferred printing them as separate parts and then gluing them together, they seem to hold together quite well (don't use too much glue).&nbsp;</p><h4>Assembly</h4><p>The parts can be glued together but it's actually not needed, they stick together pretty well anyway.&nbsp;</p><ol><li>Slide in the countertop</li><li>Place the middle part of the U shaped beams horizontally on the front stall beams and attach the ends to the back stall beams</li><li>Place the single beam on top of the back stall beams and then place the awning on top</li></ol>