Match LED Lamp 8x8 cm

thingiverse

Friday I have the idea for this lamp. The body is a square 8 to 8cm. There is a lower,a middle and a upper part for the body and a head. My lamp is 69 cm high with three body parts. One upper part, one lower part an one middle part. They are screwed together, so you can put in more middle parts if you want. When the are screwed together you are able to push in the connector cable from the top. I use a E14 socket for the bulb (2,8 x 5,8 cm). If you need other dimensions please leave a comment. At the bottom of the middle and upper part there is a inner thread. The next layer across the thread ist solid. So you have to cut the 12mm hole for the connector cable with a sharp knife. But you didn't need support to print the part (thank you for the video 3DMN). This lamp is for using on a desk. Later on I will publish a 10x10cm one for using as a floor lamp. All the parts are less than 20cm. So it should be printed at the most 3D printers. I printed my lamp with Gyroid Infill. So if you need a better stand you could drill a hole at the bottom an put in some sand. After that lock the hole with glue. For the body I use normal PLA and for the head transparent PLA. So it's highly recommended to use a LED bulb. Mine is a 2W LED Lamp from ikea. I hope you like the design. If you print one please leave a make. If you have a question please ask.