Mazda RX7 FC Heat Vent Gauge Pods

thingiverse

This is a replacement center bezel for an FC Mazda RX7 heating vent to allow for the placement of 3 x 2-1/16" diameter gauges. I have uploaded both a combined and fully separate set of STL's. I recommend printing this in ASA for both UV and heat resistance given it's location in the vehicle. This project requires the use of the factory metal retention clips that came with the original center vent assembly (4) The lower ones are very tight and should be installed carefully using a vise, or pliers such as the Knipex adjustable 86 series. The required files are as follows: Separate version: (Easier to print. No support needed) 1 x Center Vent Insert_Base.stl 1 x Gauge Volcanos.stl 1 x Rear Shroud.stl 8 x Vent Tab.stl 8 x Gauge Volcano Dowel.stl Combined version: 1 x Center Vent Insert_Pods_Combined 1 x Rear Shroud.stl 8 x Vent Tab.stl The vent tabs and dowel pins are to be glued in during assembly.