Mazikeen's Daggers(modded and split)

thingiverse

Knightfall3D's Mazikeen's Daggers(https://www.thingiverse.com/thing:4702695) beautiful props but, I noticed that in the series the inner edge of the blade is blunt. And I blunt her to the best of my ability. Also, right now my printer is unable to print objects larger than 150 150 150 mm. Therefore, I had to cut the model into a blade and a handle and built supports for printing in an upright position. I used a 0.4mm nozzle and a 0.1mm layer on PLA for printing To slice it in Cura you must open four models marked with "cut", after which highlight them and use "merge models" function.Then place the model in the middle of the table, align the orientation, and then disable the drop on the table function in the settings. Ungroup the model. And usу "per model settings" for models marked as "support" set the following settings : wall line count-1 top layers-0 bottom layers-0 infill density-0 It should look like in the screenshots Supports are removed quite easily.