Mean Well power supply bracket for Anet A8

thingiverse

UPDATE: I added an inlet/cover design for the LRS350 supply here: http://www.thingiverse.com/thing:2302140 The stock power supply that comes with the Anet A8 is well understood to be a cheap piece of junk. I recommend the Mean Well LRS-350 series supply as a cheap and dependable upgrade, and I recommend buying it from a known distributor such as Mouser to ensure that you get a genuine unit: http://mouser.com/ProductDetail/Mean-Well/LRS-350-12 However the mounting holes on the LRS supply are different from those on the stock supply. This bracket goes between the power supply and the frame and allows the supply to be mounted to the printer frame in the stock location without any modifications. You'll need four M4x8, flat head (not pan head!) screws to attach the bracket to the supply - M4x6 is too short, and DO NOT use longer screws or you can short out the guts of the supply. You'll also need three M3x16 or longer flat head screws to attach the bracket to the printer frame, and three M3 nuts (washers also recommended) to secure the M3 screws. This bracket will fit Mean Well LRS-350, NES-350, SE-350, SP-320 and possibly others. OpenSCAD design files are attached. Print Settings Printer: Anet A8 Rafts: No Supports: No Resolution: 0.2mm Infill: 25% Notes: I use 3 layers on top/bottom/sides and rectilinear infill. You may have to drill out the M3 screw holes to get the screws through, depending on your print settings.